350-601 Questions PDF [2023] Use Valid New dump to Clear Exam
Passing Cisco 350-601 Exam Using 2023 Practice Tests
NEW QUESTION # 36
Refer to the exhibit.
An engineer must distribute all the host ports to use all eight configured FEX uplinks. The solution must minimize disruption if an uplink fails Which action accomplishes this objective?
- A. Statically assign each host interface to a fabric uplink
- B. Set the pinning max-links value to 8
- C. Configure the eight uplinks in a port channel
- D. Change the supported FEX type
Answer: C
Explanation:
Traffic disruption should be minimised when an uplink fails. If pinning was used and an uplink failed, then traffic associated with the failed link would be disrupted until it could be re-routed. Using a port-channel is much less disruptive.
NEW QUESTION # 37
Drag and drop the fields for configuring a full state backup file of the Cisco UCS Manager from the left onto the descriptions on the right.
Answer:
Explanation:
NEW QUESTION # 38
An engineer is implementing security on the Cisco MDS 9000 switch. Drag drop the descriptions from the left onto the correct security features on the right.
Answer:
Explanation:
Explanation
prevent unauthorized - fabric binding.
Uses the exchange fabric membership- fabric binding
Can be distributed - port security
Allows a preconfigured - port security
NEW QUESTION # 39
Which statement is true about upgrading the firmware on a Cisco MDS storage switch with dual supervisors?
- A. Supervisors can be upgraded independently to test the new firmware.
- B. The standby supervisor must be offline before the firmware upgrade begins.
- C. Both supervisors load the new firmware and then the active supervisor reboots.
- D. The new firmware is load on the standby supervisor first.
Answer: D
Explanation:
https://www.cisco.com/c/en/us/support/docs/storage-networking/mds-9000-nx-os-san-os-software/118952- technote-mds9k-00.html#:~:text=On%20a%2095xx%20or%2097xx,becomes%20the%20new%20standby%
20supervisor.
NEW QUESTION # 40
An engineer has a primary fabric that is named UCS-A and a secondary fabric that is named UCS-B. A certificate request that has a subject name of sjc2016 for a keyring that is named kr2016 needs to be created.
The cluster IP address is 10.68.68.68. Which command set creates this certificate request?
A)
B)
C)
D)
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: C
Explanation:
Explanation
NEW QUESTION # 41
Refer to the exhibit.
Which type of backup is required to restore a Cisco UCS configuration?
- A. system configuration
- B. full state
- C. all configuration
- D. logical configuration
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/cli/config/guide/1-0-2/b_CLI_Config_Guide_1-0-2/CLI_Config_Guide_1-0-2_chapter29.pdf
NEW QUESTION # 42
Which configuration implements static ingress replication?
- A. interface nve 1
member vni 2100980
ingress-replication protocol static
peer-ip 10.0.0.4 - B. interface nve 1
member vni 127772151
ingress-replication protocol bgp - C. interface nve 1
member vni 384233213
peer vtep 10.0.0.41 - D. interface nve 1
member vni 3126980
peervtep 10.0.0.4
ingress-replication protocol static
peer-ip 10.0.0.4
Answer: A
NEW QUESTION # 43
Which adjacency server configuration makes two OTV edge devices located in the same site bring up the dual-site adjacency?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: B
NEW QUESTION # 44
Which statement is true about upgrading the firmware on a Cisco MDS storage switch with dual supervisors?
- A. Supervisors can be upgraded independently to test the new firmware.
- B. The new firmware is loaded on the standby supervisor first.
- C. The standby supervisor must be offline before the firmware upgrade begins.
- D. Both supervisors load the new firmware and then the active supervisor reboots.
Answer: B
Explanation:
Section: Storage Network
NEW QUESTION # 45
Refer to the exhibit.
Which setting must be configured to prevent reuse of passwords?
- A. Change Count
- B. No Change Interval
- C. Change Interval
- D. History Count
Answer: D
NEW QUESTION # 46
An engineer must configure a named VSAN when the fabric interconnect is in Fibre Channel switch mode The VSAN must meet these requirements:
* Named VSAN must be called "VSAN 10".
* VSAN ID must be 10.
* FCoE ID must be 20.
* VSAN 10 must be attached to port 2 in slot 1.
Which command set configures a VSAN when the fabric interconnect is in Fibre Channel switch mode?
- A. Option B
- B. Option A
- C. Option C
- D. Option D
Answer: B
NEW QUESTION # 47
What is an advantage of NFS as compared to Fibre Channel?
- A. NFS provides the dynamic allocation of storage capacity.
- B. NFS provides direct access to the underlying storage hardware.
- C. NFS removes the impact of IP overhead.
- D. NFS enable thin provisioning for LUNs.
Answer: A
Explanation:
https://www.ciscolive.com/c/dam/r/ciscolive/apjc/docs/2018/pdf/BRKINI-1011.pdf
NEW QUESTION # 48
A host EPG Client wants to talk to a webserver in EGP Web. A contract with default settings is defined between EPG Client and EPG Web, which allows TCP communication initiated by the client toward the webserver with TCP destination port 80. Which statement is true?
- A. If vzAny is configured to consume and provide a "deny all" contract, traffic between EPG Client and EPG Web is no longer allowed.
- B. The host in EPG Client is allowed to connect to TCP destination port 80 on the webserver in EPG Web.
The webserver is allowed to initiate a separate TCP connection to a host port with TCP source port 80. - C. The host in EPG Client is allowed to connect to TCP destination port 80 on the webserver in EPG Web.
The webserver will not be allowed to initiate a separate TCP connection to a host port with TCP source port 80. - D. If EPG Web is made a preferred group member, a contract between EPG Client and EPG Web is no longer required for the host in EPG Client to reach the webserver in EPG Web.
Answer: B
Explanation:
Apply Both Direction and Reverse Filter Port in the subject for the filter. These two options are by default enabled...This means that if the provider EPG initiates traffic toward the consumer EPG, the Cisco ACI fabric allows it for any destination ports if the source port is 80.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI/guide/ b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_01000.html Reverse filter and apply in both directions is default.
If a filter allows traffic from any consumer port to a provider port (e.g. 8888), if reverse port filtering is enabled and the contract is applied both directions (say for TCP traffic), either the consumer or the provider can initiate communication. The provider could open up a TCP socket to the consumer using port 8888, whether the provider or consumer sent traffic first.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI/guide/ b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_01000.html
NEW QUESTION # 49
What are two types of FC/FCoE oversubscription ratios? (Choose two.)
- A. edge ISL bandwidth to core ISL bandwidth
- B. server storage to end-node count
- C. host bandwidth to storage bandwidth
- D. port bandwidth to uplink bandwidth
- E. switch processing power to end-node processing power
Answer: A,C
Explanation:
Explanation
https://www.ciscolive.com/c/dam/r/ciscolive/us/docs/2017/pdf/BRKDCN-1121.pdf
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/operations/n5k_fcoe_ops.html
NEW QUESTION # 50
Refer to the exhibit.
What is the outcome of this command when the ELPD is updated on a Cisco Nexus 9000 series switch?
- A. displays the impact of the upgrade on the operation of the switch
- B. shows a simulated upgrade of the EPLD
- C. upgrades the EPLD on the switch disruptively
- D. displays the compatibility of the EPLD upgrade and the image in the bootflash
Answer: A
NEW QUESTION # 51
A Cisco UCS C-Series server is installed at a data center. The server should be managed by the Cisco UCS Manager by using a single cable for management and data traffic. Which configuration should be applied after the Physical connection is established?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: B
NEW QUESTION # 52
......
The Cisco 350-601 (Implementing Cisco Data Center Core Technologies (350-601 DCCOR)) certification exam is an excellent certification to have if you are looking to enhance your career prospects in the field of data center technologies. The exam covers a wide range of topics related to data center technologies and requires extensive preparation and study. Candidates who pass this exam demonstrate their proficiency in implementing core data center technologies and are therefore more likely to be considered for high-paying and challenging roles in the field of data center technologies.
To prepare for the Cisco 350-601 exam, candidates can take advantage of the training and resources available from Cisco. These include instructor-led courses, e-learning modules, and study materials such as books and practice exams. Candidates can also participate in online discussion forums and study groups to share knowledge and collaborate with other professionals preparing for the exam.
The Cisco 350-601 exam is a prerequisite for several Cisco certifications, including the Cisco Certified Network Professional Data Center (CCNP Data Center) and the Cisco Certified Internetwork Expert Data Center (CCIE Data Center). By passing this exam, candidates can demonstrate their expertise in data center technologies and enhance their career prospects.
350-601 Study Guide Brilliant 350-601 Exam Dumps PDF: https://freetorrent.braindumpsvce.com/350-601_exam-dumps-torrent.html