Ace 300-425 Certification with 113 Actual Questions
PASS Cisco 300-425 EXAM WITH UPDATED DUMPS
NEW QUESTION 29
A university is in the process of designing a wireless network in an auditorium that seats 500 students and supports student laptops. Which design methodology should the university implement in the auditorium?
- A. roaming design model
- B. voice design model
- C. high-density design model
- D. location design model
Answer: B
Explanation:
https://www.cisco.com/c/dam/en_us/solutions/industries/docs/education/cisco_wlan_design_guide.pdf
NEW QUESTION 30
Which non-Wi-Fi interferer can be identified by Metageek Chanalyzer?
- A. jammers
- B. printers
- C. smartphones
- D. PDAs
Answer: A
Explanation:
Section: Wireless Site Survey
Explanation/Reference:
NEW QUESTION 31
Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?
- A. EIGRP
- B. BGP
- C. NHRP
- D. LLDP
Answer: C
Explanation:
Explanation
NEW QUESTION 32
Guest anchoring is configured for a newly created SSID for your company. It has been noticed that the mobility tunnels are not up, and that MPING fails from your foreign WLC to the anchor WLC. What is the reason that it is failing?
- A. A rule is needed at the firewall to allow UDP port 16666 for communication to work.
- B. A rule is needed at the firewall to allow TCP port 97 for communication to work.
- C. A rule is needed at the firewall to allow UDP port 97 for communication to work.
- D. A rule is needed at the firewall to allow TCP port 16666 for communication to work.
Answer: A
NEW QUESTION 33
Refer to the exhibit. An enterprise is using wireless as the main network connectivity for clients. To ensure service continuity. a pair of controllers will be installed in a datacentre. An engineer is designing SSO on the pair of controllers. What needs to be included in the design to avoid having the secondary controller go into maintenance mode?
- A. The Global Configuration of SSO is set to Disabled on the controller.
- B. The connection between the redundancy ports is missing.
- C. The redundancy port must be the same subnet as the redundancy mgmt.
- D. The Keep alive timer is too low. which causes synchronization problems.
Answer: B
Explanation:
'There are few scenarios where the Standby WLC may go into Maintenance Mode and not be able to communicate with the network and peer: * Non reachability to Gateway via Redundant Management Interface * WLC with HA SKU which had never discovered peer * Redundant Port is down * Software version mismatch (WLC which boots up first goes into active mode and the other WLC in Maintenance Mode)' High Availability (SSO) Deployment Guide - Cisco
NEW QUESTION 34
When conducting a site survey for real-time traffic over wireless, which two design capabilities of smartphones and tablets must be considered? (Choose two.)
- A. higher data rates than laptops
- B. no support for 802.11r
- C. lower data rates than laptops
- D. no support for 802.11ac
- E. fewer antennas than laptops
Answer: C,E
Explanation:
NEW QUESTION 35
Which statement about creating a mobility group is true, excluding mobility anchors?
- A. The WLCs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.
- B. Each WLC must use the same mobility name and be defined as a peer in each other's static mobility members list.
- C. A mobility groups does not require all WLCs in the group to use the same virtual IP address.
- D. If WLCs with HA SSO are deployed, each WLC in the WLC HA pair considered separately as a mobility peer.
Answer: D
Explanation:
NEW QUESTION 36
A wireless engineer is using Ekahau site survey to validate that an existing wireless network is operating as expected, which type of survey should be using to identify the end-to-end network performance?
- A. Passive
- B. Active ping
- C. Spectrum analysis
- D. GPS assisted
Answer: C
Explanation:
https://support.ekahau.com/hc/en-us/articles/115004973067-Spectrum-Analysis-Surveys
NEW QUESTION 37
An engineer is designing a wireless deployment for a university auditorium. Which two features can be used to help deal with the issues introduced by high AP count? (Choose two.)
- A. DFS
- B. RXSOP
- C. TSPEC
- D. TPC
- E. LSS
Answer: A,D
Explanation:
Section: Wired and Wireless Infrastructure
NEW QUESTION 38
An engineer is designing a network deployment for a college with six buildings Each building must have a WLC located in the IDF to support the APs. The wireless clients should be able to roam between the APs and the controllers. Which type of wireless architecture should be used?
- A. Distributed
- B. Autonomous
- C. Cloud
- D. Centralized
Answer: D
Explanation:
Cloud-based architecture has controllers in the cloud, not on premises. Autonomous architecture means each AP is autonomous and is not managed by a WLC, distributed architecture is another term for autonomous architecture, so the same applies. Centralized architecture, a.k.a. split-MAC architecture is when all APs are managed centrally by WLCs, they do not need to be co-located. Understanding Cisco Wireless Architectures - CCNA Wireless 200-355 Official Cert Guide (2016) (apprize.best)
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/emob41dg/emob41dg-wrapper/ch2_Arch.html
NEW QUESTION 39
A technician connects a Cisco Aironet 3700 Series access point to a switch and realizes that the AP is coming up with 3x3 MIMO. Which reason explains this behavior?
- A. The switch is PoE+ capable.
- B. A redundant power supply is unavailable on the switch.
- C. The AP is getting power from a power injector.
- D. The switch is 802.3af capable.
Answer: A
Explanation:
NEW QUESTION 40
Refer to the exhibit.
Which two statements about Cisco Prime Infrastructure are true? (Choose two.)
- A. Controllers must be synchronized with Cisco Prime Infrastructure for planning mode to work.
- B. It shows the planning mode feature in Cisco Prime Infrastructure.
- C. It presents the recommended number of APs for the selected coverage area based on the selections made.
- D. Planning mode requires a special license in Cisco Prime Infrastructure.
- E. It shows the map editor feature in Cisco Prime Infrastructure.
Answer: B,C
Explanation:
NEW QUESTION 41
The wireless team must configure a new voice SSID for optimized roaming across multiple WLCs with Cisco 8821 phones. Which two settings accomplish this goal? (Choose two.)
- A. Configure mobility groups between WLCs.
- B. Use AVC to tag traffic voice traffic as best effort.
- C. Use Cisco Centralized Key Management for authentication.
- D. Configure AP groups between WLCs.
- E. Configure AVC profile on new SSID.
Answer: A,C
NEW QUESTION 42
What is the recommended cell overlap when designing a wireless network for Cisco Hyperlocation?
- A. 50%
- B. 20%
- C. 40%
- D. 30%
Answer: B
Explanation:
NEW QUESTION 43
Which two statements indicate a valid association mode for NTP synchronization? (Choose two.)
- A. The client polls NTP servers for time.
- B. The client multicasts NTP requests.
- C. The client broadcasts NTP requests.
- D. The client listens to NTP broadcasts.
- E. The client creates a VPN tunnel to an NTP server.
Answer: A,D
NEW QUESTION 44
Which statement about the 9800 Series Wireless Controller mobility tunnel on a Cisco Catalyst 9800 controller is true?
- A. It is an IPsec tunnel with control path and data path.
- B. It is a CAPWAP tunnel with control path and data path.
- C. It is an IPsec tunnel with control path only.
- D. It is a CAPWAP tunnel with data path only.
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/mobility.html
NEW QUESTION 45
An engineer must create data link redundancy for the company's Cisco Wireless LAN controller. The engineer has decided to configure LAG-based redundancy instead of port-based redundancy. Which three features of LAG-based redundancy influenced this decision? (Choose three.)
- A. Ports are grouped into multiple LAGs.
- B. Packets are always sent out on the same port they are received on.
- C. Interface connection to two separate nonstacked switches is available.
- D. All interface traffic passes as long as one port is up.
- E. Full bandwidth of all links is available.
- F. The same port has multiple untagged dynamic interfaces.
Answer: A,B,D
Explanation:
https://community.cisco.com/t5/wireless-mobility-documents/lag-link-aggregation/ta-p/3128669
NEW QUESTION 46
Which statement about AP failover priority for access points when configured with priority 1 or 4 is true?
- A. When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
- B. When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.
- C. When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.
- D. When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.
Answer: A
Explanation:
NEW QUESTION 47
An engineer has successfully configured high availability and SSO using two Cisco 5508 Wireless LAN Controllers. The engineer can access the Active Primary WLC, but the Secondary Standby WLC is not accessible. Which two methods allow access to the standby unit? (Choose two.)
- A. SSH to the virtual interface of the secondary WLC
- B. SSH to the service port interface
- C. via the console connection
- D. SSH to the management interface of the primary WLC
- E. SSH to the redundancy management interface of the primary WLC
Answer: B,C
Explanation:
NEW QUESTION 48
An engineer Is trying to determine the most cost-effective way to deploy high availability for a campus enterprise wireless network that currently leverages three wireless LAN controllers. Which architecture should the engineer deploy?
- A. N+N solution without SSO
- B. N+1 with SSO
- C. N+1 solution without SS0
- D. N+N with SSO
Answer: B
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/technology/hi_avail/N1_High_Availability_Deployment_Gu
NEW QUESTION 49
Which CLI command does an engineer use to validate that the redundancy peer of a Stateful Switchover pair of controllers is up and connected?
- A. mping
- B. ping
- C. rping
- D. eping
Answer: B
Explanation:
NEW QUESTION 50
......
Target Audience and Recommended Experience
The Cisco 300-425 exam is designed for the IT professionals who design Cisco wireless networks. It is appropriate for Wireless Engineers, Sales Engineers, Wireless Design Engineers, System Engineers, and Sales Engineers. Other specialists who should take this test are Consulting Systems Engineers, Network Engineers, Network Administrators, and Network Managers.
To pass this certification exam, the applicants need to be familiar with the general knowledge of wireless networks. They should also have some expertise in routing and switching. In addition, the learners should be able to demonstrate their knowledge of wireless network design. They must be knowledgeable about site surveys, mobility, WLAN high availability, as well as wired and wireless infrastructure.
What is Salary of Cisco 300-425 exam
The CCENT certification is a good start in the Cisco certification track. The salary of CCENT level professionals would be 45,000 USD and the salary could reach 99,000 USD with senior professionals.
300-425 Questions PDF [2023] Use Valid New dump to Clear Exam: https://freetorrent.braindumpsvce.com/300-425_exam-dumps-torrent.html